Vicon surveyor 1000, Руководство по установке и эксплуатации

Страница: 23 / 62

XX100-00-01 Rev 202 Surveyor1000 Camera Dome System Installation
••••
17
Optional Independent Support
If it is necessary to provide independent support for the Surveyor1000, other than the ceiling material, order
the optional In-Ceiling Mount Model Kit. It consists of a pre-assembled set of Mounting Rails and folding Ring
as shown in Figure 11.
1. With the 7-3/8-inch (187 mm)
diameter hole cut in the
ceiling tile and tile replaced in
the ceiling, push the folded
assembly up through the hole
and unfold.
2. Position the assembly
squarely over the hole and
fasten the Caddy Rail Clips to
the existing frame. Remove
adjacent tiles to access the
clips.
3. Adjust the position of the
Caddy Rail Clips along the
frame to obtain the best “X”
position.
4. Slide the assembly along the
Caddy Rails to obtain the best
concentric “Y” position.
Tighten the horizontal
adjustment screws to secure
the position.
5. With the Ring concentric with
the hole, slide the ring
vertically along the support
slots to obtain the best flush fit
in the ceiling. The Ring should
be firmly seated against the
tile without warping the tile as
shown in Figure 12.
6. Finally,
complete the
installation as described in the
procedure of the previous
sub-sections. In this
installation, the Flippers will
secure the Enclosure to the
Mounting Ring Assembly
instead of the tile.
Figure 11
Optional In-Ceiling Mount Model Kit Installation
Figure 12
Optional In-Ceiling Mount Model Kit Installation