Vicon surveyor 1000, Руководство по установке и эксплуатации

Страница: 15 / 62

XX100-00-01 Rev 202 Surveyor1000 Camera Dome System Installation
••••
9
Detailed Installation
For novice or first-time installers, these steps provide the most thorough and accurate instructions.
Use of the Provided Scribe
A small metal scribe is provided to assist in marking an accurate hole size in a ceiling tile. Use as follows:
1. Place a ceiling tile on a large flat surface, face up.
2. Measure and make a small mark at position
A
from corner (11.9 in/302 mm). Refer to Figure 4.
3. Measure and make a small mark at position
B
(8.2 in/208 mm), placing the Scribe as
perpendicular to the
A- edge as possible.
4. Place the Scribe across positions
B and C .
Rotate the Scribe around center
C
for a full turn.
5. Cut out the circle, using a sharp tool, on the
scribed line.
In-Ceiling Mount Model
This version of Surveyor1000 mounts in the ceiling.
The Surveyor1000 rests on the ceiling material and
occupies the space between the lower ceiling and
upper building frame. This section details 2 methods
of installation. The first method can be used for
ceilings with no access to the space above, as in a
typical hard material ceiling. The second method is
used for a ceiling with access, as in the case of a
dropped ceiling (metal grid type). All mounting
hardware is provided.
From Below the Ceiling (no access to the
space above)
The Camera Drive is removed from the Enclosure.
The ceiling hole is cut using the Scribe and the
Enclosure is prepared with Flexible Conduit or cabling
below the ceiling. The Enclosure is then lifted up
through ceiling hole and the Flipper Screws are
turned and tightened against the ceiling. Then the
Camera Drive is hung from the Enclosure’s Safety
Cord, wired, configured and screwed back into the
Enclosure. The Indoor Lower Dome is then snapped
on. The Surveyor1000 is secured with the Flippers.
The Surveyor1000’s horizontal position is determined
by the hole placement. Refer to Figure 5 for
installation details.
Figure 4
Use of the Scribe
Figure 5
Ceiling Mount Model, No Ceiling Access Provided