Vicon surveyor 1000, Руководство по установке и эксплуатации

Страница: 9 / 62

XX100-00-01 Rev 202 Surveyor1000 Camera Dome System Introduction
••••
3
Surveyor1000 Components
All Surveyor1000 versions are comprised of an Enclosure, a removable
Camera Drive, a Shroud and a Lower Dome. This assembly is the heart of
every prepackaged Surveyor1000 unit. Figure 1 shows an In-Ceiling model,
Figure 2 shows an Indoor Pendant model and Figure 3 shows an Outdoor
Pendant Model.
Enclosure
The Enclosure is a metal shell that houses Camera Drive on 3 standoffs. A
Safety Cord and Clip are provided to connect to the Camera Drive Latch
during installation. In addition, a small hole is provided on the Enclosure’s lip
for connection of the Lower Dome’s Plug. A Top Cover, a standard 0.5-inch
(13 mm) Conduit Fitting and a pair of Flippers are provided for the In-Ceiling
Mount Model. The Top Cover is attached with 3 screws. For In-Ceiling
installations that do not use conduit pipe, a standard 0.5-inch (13 mm) Strain
Relief Fitting provides solid cable anchoring at the Enclosure. Two rotating
Flippers are used to give a convenient and sturdy connection of the
Enclosure into the ceiling. The Pendant models do not use Flippers.
Camera Drive
The Camera Drive is comprised of an integral Camera, Pan-and-Tilt Drive
and CPU. The Camera Drive quickly and accurately positions the Camera in
360
°
of pan angle and 90
°
of tilt angle. All wiring is made directly to the top
of the Camera Drive. There are variations in camera type for format,
magnification and day/night usage.
Shroud
The Shroud is a 5.4 inch (137 mm) textured black ABS plastic shell. It has a
1.2 inch (30.5 mm) slotted opening for the Camera. This Shroud helps
conceal the position of the Camera and snaps onto the Camera Drive.
Lower Dome
The Lower Dome is an assembly comprised of a 5.9 inch (150 mm) diameter
acrylic plastic shell, a Trim Ring and a Safety Cord. Lower Domes for indoor
versions come in a choice of Smoked, Chrome or Gold finishes. Outdoor
Lower Domes are clear and use 4 screws for additional support. All Lower
Domes are anchored to the Enclosure by the Safety Cord. Refer to the
Maintenance Section for instructions on care of this Lower Dome.
Housing
The Housing is a molded plastic protective cover for the Enclosure. It is used
in the Surveyor1000 Indoor Pendant configuration. The Housing contains
two Spring Clips that snap into the Enclosure and a 1.0-inch NPT Pipe
flange mount. In addition, the Housing is equipped with a Safety Cord and
Clip that is used to suspend the Enclosure during installation.
Sunshield/Housing Assembly
The Sunshield is used on the Outdoor Pendant version and is pre-installed
over the Housing. It incorporates an O-ring seal and a Foam Barrier. It is
used for environmental sealing from water, dust and debris. In addition, a
thermostatically-controlled Heater is provided for temperature control.
CAUTION: For any environment subject to moisture, use the Outdoor
Pendant Model.
Figure 1
Surveyor1000 In-Ceiling