31
XX207-20-03 Rev 611 MPD-980DN-O Camera Dome
Troubleshooting
Status LED
The following table lists the Status LED patterns.
Reset and Restore
There is a button on the rim of the camera dome. It is used to reset the system or restore the factory default
settings. Sometimes resetting the system sets the system back to normal state. If the system problems re-
main after reset, restore the factory settings and install again.
RESET: Press and release the button with a thin object. The camera reboots.
RESTORE:
1. Press and hold the reset button until the status LED rapidly blinks. It takes about 30 seconds.
2. Upon successful restore, the status LED will blink green.
