Viadrus EKORET SAPHIR 15, Руководство по эксплуатации и установке

Страница: 4 / 68

4
Tab. no. 2a) Heating technical parameters of EKORET SAPHIR 15 boiler
HARD COAL LIGNITE PELLETS
Nominal output kW 15 15 15
Fuel consumption kg.h
-1
2,58 3,34 3,8
Fuel efficiency MJ.kg
-1
25,16 19,17 16,78
Fuel consumption in the holding regime kg.h
-1
0,13 0,10 0,70
Burning time at nominal output – small reservoir
h 67 h 40 min 52 h 30 min 41 h 50 min
Burning time at nominal output – large reservoir h 132 h 49 min 103 h 82 h 7 min
Efficiency %
Up to
83,2
Up to
84,3
Up to
84,7
Flue gas temperature °C 160 160 160
Flue gas mass flow at nominal output g.s
-1
15,97 18,00 18,01
Boiler class 3 3 3
Tab. no. 2b) Heating technical parameters of EKORET SAPHIR 25 boiler
HARD COAL LIGNITE PELLETS
Nominal output kW 22 22 22
Fuel consumption kg.h
-1
3,65 4,72 5,45
Fuel efficiency MJ.kg
-1
25,16 19,17 16,78
Fuel consumption in the holding regime kg.h
-1
0,13 0,10 0,70
Burning time at nominal output – small reservoir h 45 h 50 min 35 h 30 min 25 h 10 min
Burning time at nominal output – large reservoir h 90 h 10 min 69 h 40 min 49 h 24 min
Efficiency %
Up to
86,4
Up to
87,7
Up to
86,6
Flue gas temperature °C 190 160 180
Flue gas mass flow at nominal output g.s
-1
16,04 17,64 16,18
Boiler class 3 3 3
! Important notice:
The above mentioned heating technical parameters vary according to the type, quality and moisture
of the fuel used. Therefore there may be necessary corrections at setting of feeding time (proportion
of fuel feeding and fuel afterburning time). For example, if there occur the sliver parts of fuel on the
fire grate and in the ash pan, it is evident, that the speed of feeding is higher than the speed of
afterburning, in this case it is necessary to decrease the feeding cycle.
Specified fuel parameters – fuel which was tested by SZÚ:
•
Granularity 5 - 25 mm
•
Recommended heating value > 15 MJ. kg
-1
•
Ash content max. 15 %
•
Water content max. 12 % (hard coal, wood pellets),
max. 20 % (lignite)
•
Volatile combustible content 28 - 40 %
•
Ash deformation temperature by melting > 1150 °C
•
Low agglutinating power
•
Low creeping
Values state in fig. no. 1 and Fig. no. 2 were measured out by using the specified fuel in tests.
Tab. no. 3 Specified fuel
Fuel Sort of fuel
Granularity
[mm]
Fuel value
[MJ.kg
-1
]
Hard coal Peas 10 – 18 21 – 28,5
Lignite
Nub 2 10 – 25 16,5 – 19,5
Nub 3 10 – 16 16,5 – 19,5
Biomass Wood pellets Ø 6 - 8 15 – 19
Tab. no. 4 Specified fuel – lignite (Automatic operation)
Fuel
Granularity
[mm]
Fuel
value
[MJ.kg
-1
]
Ash content
[%]
water
content
[%]
sulphur
content
[%]
Specific
sulphur
content
[g/MJ]
Tar
content in
dry matter
[%]
Tar content in
combustible
matter [%]
Screened lignite from
Bílina mine
(coal cleaning plant) –
nub 2
10 - 25 17,6
9,8
(in
anhydrous
condition)
max. 20 0,77 0,44 15,1 15,71