Viadrus EKORET SAPHIR 15, Руководство по эксплуатации и установке

Страница: 42 / 68

42
Parameter Description Units
Set by the
manufacturer
Range Resolution
P 225 Ventilator Y3 pellets [%] 24/37 14…40/25…50 1
P 226 Ventilator X4 pellets [%] 100 100 0
P 227 Ventilator Y4 pellets [%] 32/41 20…45/25…60 1
P 228
Ventilator slowing-down in the attenuation
regime– pellets
[s] 3 1 … 60 1
P 229 Ventilator output in the attenuation – pellets [%] 100 50 … 100 1
P 231 Superior control ON / OFF 0 0 … 1 1
P 232 Outside sensor deactivation 1 0 … 1 1
P 233 Diagnostics HC - - -
P 234 Diagnostics boiler - - -
P 235 Restoration of manufacturer’s setting 0 0 … 1 1
P 238 Year - 2000 - 2050 1
P 239 Date - 01.01. – 31. 12. Day
P 240 Time - 00:00 – 23:59 Minute
6.2.1 Description of SAPHIR regulator parameters
P 1
Current outside temperature [
o
C]
Current outside temperature displayed. The lowest displayed value of outside temperature is -20
o
C.
P 2
Current boiler temperature [
o
C]
Current boiler outlet temperature displayed.
P 3
Current heating circuit temperature [
o
C]
Current heating circuit temperature displayed
P 4
Desired heating circuit temperature [
o
C]
Current desired heating circuit temperature displayed
P 5
Current temperature HW [
o
C]
Current HW temperature displayed
P 6
Desired boiler temperature in case of HW heating [
o
C]
Current desired boiler outlet temperature in case of water demand on heating displayed
P 7
Current warm water thermostat status [
o
C]
Current HW thermostat status displayed
P 8
Current feeder temperature [
o
C]
Current feeder temperature displayed
P 9
Current space temperature [
o
C]
Current space temperature displayed
P 10
Current position of three-way mixing valve [%]
Current position of three-way mixing valve displayed
P 11
Desired boiler temperature [
o
C]
Current desired boiler outlet temperature displayed
P 12
Current ventilator output [%]
Current ventilator output displayed
P 15
Faults
Current boiler fault displayed. Description of individual faults see tab. no. 8.
In case 0 is on the line no fault is detected.
P 19
Parallel shift in the heating curve [
o
C]
By increasing the value the parallel shift in heating curve will occur (parameter P 21) thus the desired
heating water temperature will be increased
P 20
Fuel type
Selection of required fuel (value 1, 2, 3)
1 – lignite
2 – hard coal
3 – wood pellets