DVB Series Direct Vent Gas Fireplace
38
20306740
SIGNATURE COMMAND SYSTEM OPERATION
FEATURES
Command Center
•
Easy Access Function Operation and System
Configuration
•
Operation Confirmation/Fault Diagnostic Indications
(LED/Buzzer)
•
ON/OFF/HI/Med/Low Operation
•
Optional Wall Mounting
Control Board
•
Electronic Ignition
•
Pilot Lockout safety feature
•
Electric Power Regeneration from Thermopile to save
battery
•
6-hour Automatic Shut Down Option
•
Convenient NG/LP Gas Type Conversion
•
Standing Pilot/Intermittent pilot Conversion
•
Previous settings Restoration Ability (Memory Off)
•
Uninterrupted Operation During Power Outage
(Automatic Battery Backup)
•
ON/OFF RF Remote Receiver
•
Optional Transmitter Learn Capability
AC Module Board
(Optional, requires TSFSC Remote)
•
Easy Snap-on Design
•
Embedded Compact 120 VAC Adapter with Auto
Battery Back up Feature
•
Remote Controlled 3-step Blower, Lighting, and On/
Off Auxiliary AC Outputs
FP1917
Signature components
8/08
RF Receiver
ON/OFF
NG/LP
Conversion
To Thermopile
To Sensor
To Sparker
To Command Center
To Stepper Motor
To Valve
FP1917
Signature components
8/08
Battery Door
Master Switch
ON
LED
OFF
Control
Board
Command
Center
Figure 57 -
Signature Command System Components
Transmitter (Optional
)
TSFSC
TSTSC
TSMSC
RTSC
RMSC
Three Flame Height Settings
X
X
X
X
X
Low battery Indication for Transmitter
X
X
X
X
X
Child Proof Lock-out
X
X
X
X
X
LCD Backlight
X
X
X
X
X
Security Codes 16
X
X
X
X
X
Countdown 6 Hr Timer
X
X
X
--
--
Standard Thermostatic Control Mode
X
X
--
X
--
Smart Mode
®
Thermostat (Auto Flame & Blower Modulation)
X
X
--
--
--
Three Brightness Settings for Lights
X
--
--
--
--
Three Speed Control for Blower
X
--
--
--
--
On/Off Auxiliary
X
--
--
--
--
Programmable Timer to turn blower on and off
X
--
--
--
--
BATTERY INSTALLATION
The Command Center uses four (4) "AA" batteries as
back up for power outages. The system can operate for
approximately six (6) months on battery power.
To Install Batteries (not included):
1. Press down the battery door tabs and pull out to remove
battery door.
2. Install the batteries as indicated on Command Center.
3. Close battery door by snapping in place.
4. When the four (4) batteries are installed the system will
operate without power.
5. The batteries should be replaced when the LED
indicates low battery or at least once a year.
