vc999 K5, Руководство по эксплуатации

Страница: 24 / 55

K5/K5N Vacuum Packaging Machine
Operation
2002-04-25
Art. no. 519.339 DE Page 2 4/55
9.3.4 Adapting the packaging machine to suit the product
Filling plates
The best packaging results are achieved if the top
edge of the welding cap pass (1) is located at half the
height of the product.
The packaging cycle can be optimised by inserting
filling plates (2) into the vacuum chamber:
§
The product can be perfectly positioned in terms
of the height of the welding seam.
§
Filling plates reduce the vacuum volume. This, in
turn, shortens the cycle time.
Fig. 9/3
When you ins ert the filling plates, please note the
following:
§
First of all, place the first filling plate (2) carefully
against the welding cap pass (1) as shown with
the pegs (3) pointing upwards.
§
Hold the filling plate by the two grip hol es and
slide in into the vacuum chamber. You can tell
that the filling plate is in the correct position if it is
fixed in place by the screw heads (4) on the
bottom of the chamber. As you insert other filling
plates, they are held in place by the pegs (3).
Fig. 9/4
IMPORTANT
Insert the filling plates carefully! Take particular care to ensure that you do not knock the filling
plates against the welding cap passes and that the silicone insert on the welding cap pass is
not damaged!
§
Insert as many filling plates as it takes to ensure that the middle of the product being packaged is at
the same height as the top of the welding cap pass .
Angled insert
The angled insert (5) is used t o position vacuum
bags which are filled with liquid.
Fig. 9/5