CHAPITRE 3 - UTILISATION
66
87-900-045-01
(D)
3.2 MISE EN MARCHE DE L'HELITEST
Mettre en marche l'HeliTest en appuyant sur la touche
"ON". L'affichage indiquera figure 3-4.
- - - - H e l i T e s t - - - -
B i e n v e n u e *
Figure 3-4
NOTE
Si les messages ne sont pas exprimés en français, se
référer au paragraphe 3.1 pour un changement de
language.
3.2.1 Auto-contrôle
Pendant environ 4 secondes après la mise en marche,
l'HeliTest effectuera une procédure d'auto-contrôle et
l'affichage indiquera figure 3-5.
P r o
c
e d
u r e
d’ a u t o - c o n t r o l e
*
Figure 3-5
NOTE
Pendant l'utilisation et les tests de contrôle, un
astérisque clignote en bas à droite de l'affichage.
L'utilisateur ne doit pas intervenir avant la fin de la
procédure d'auto-contrôle ou avant qu'un défaut
éventuel ne soit détecté.
L'affichage indiquera après quelques secondes la
figure 3-6.
T e s t d e
c h a u f f e
*
Figure 3-6
A la fin du test du filament de chauffage (environ 4
secondes), l'affichage indiquera, si le résultat est positif
figure 3-7.
T e s t d e
c h a u f f e
O K
*
Figure 3-7
ou figure 3-8 si le résultat est négatif et le filament
défectueux.
C h a u f e r e t t e
D E F E C T U E U S E
Figure 3-8
NOTE
Lorsque ce message est affiché, la procédure d'auto-
contrôle est arrêtée. Ce message reste affiché
pendant une minute, puis l'HeliTest est
automatiquement arrêté.
Répéter alors une fois de plus la procédure à partir du
paragraphe 3.2.
Si le filament est toujours détecté comme défectueux,
contacter votre interlocuteur.
Ensuite l'appareil effectue un test de batterie
(figure 3-9).
T e s t d e
b a t t e r
i e
*
Figure 3-9
A la suite de ce test, si la tension est supérieure à 11,2
Vdc, l'affichage indique figure 3-10.
T e s t d e
b a t t e r
i e
O K
*
Figure 3-10