CAPITOLO 3 – ISTRUZIONI OPERATIVE
41
87-900-045-01
(D)
3.2 ACCENSIONE DELL'HELITEST
Accendere l'HeliTest premendo il tasto ON; il display
visualizza (fig. 3-4):
- - - - H e l i T e s t - - - -
B
e
n
v e n
u t i *
Figura 3-4
NOTA
Se la lingua non è quella desiderata, per cambiarla fare
riferimento al paragrafo 3-1.
3.2.1 Autodiagnosi
Dopo circa 4 secondi dall'accensione, l'HeliTest inizia
automaticamente la procedura di autodiagnosi ed il
display visualizza (fig. 3-5):
P r o
c e
d
u r a d i
a u t o d i a g n o s i *
Figura 3-5
NOTA
Durante l'autodiagnosi e il funzionamento, lampeggia
un asterisco, nella parte in fondo a destra del
visualizzatore.
L'operatore non deve intervenire fino a che
l'autodiagnosi è terminata o viene segnalato un difetto.
Dopo circa 4 secondi inizia il controllo del riscal- datore
ed il display visualizza (fig. 3-6):
R i s c a
l d a t o r e
*
Figura 3-6
Se la prova ha avuto buon esito, al termine della stessa
(circa 4 secondi) il display visualizza (fig. 3-7):
R i s c a
l d a t o r e
O K
*
Figura 3-7
Se la prova è negativa e il riscaldatore è difettoso, il
display visualizza (fig. 3-8):
R i s c a
l d a t o r e
D I F E T
T
O
S
O
Figura 3-8
NOTA
Quando viene visualizzato questo messaggio, la
procedura di auto-diagnosi si interrompe. Questo
messaggio rimane visibile per 1 minuto, poi l'HeliTest si
spegne automaticamente. Ripetere ancora una volta la
procedura partendo dal paragrafo 3.2.
Se il riscaldatore risulta ancora "DIFETTOSO",
contattare l'ufficio vendite.
Successivamente, viene controllata la batteria ed il
display visualizza (fig. 3-9):
B a t t e r i a
*
Figura 3-9
Alla fine della prova, se la tensione della batteria risulta
superiore a 11,2 Vdc, sul display viene visualizzato
(fig. 3-10):
B a t t e r i a
O K
*
Figura 3-10