CAPITOLO 3 – ISTRUZIONI OPERATIVE
43
87-900-045-01
(D)
Successivamente viene controllata l'efficienza della
linea e della pompa di campionamento ed il display
visualizza (fig. 3-18):
C a m p i o n a m e n t o
*
Figura 3-18
Se la prova ha esito positivo, dopo circa 10 secondi, il
display visualizza (fig. 3-19):
C a m p i o n a m e n t o
O K
*
Figura 3-19
Se la prova della linea di campionamento o della
pompa è negativa, il display visualizza (fig. 3-20):
C a m p i o n a m e n t o
D I F
E
T
T O
S
O *
Figura 3-20
NOTA
Questo messaggio rimane visibile per 1 minuto, poi
l'HeliTest si spegne automaticamente.
L'operatore deve:
- controllare e rimuovere la polvere presente nel filtro
della sonda e/o dell'asta telescopica (rif. sez. IV,
manutenzione);
- ripetere la procedura di autodiagnosi seguendo il
paragrafo 3.2.
Se la linea di campionamento risulta ancora difettosa,
contattare l'ufficio vendite.
Se la prova risulta OK, dopo circa 10 secondi
l'autodiagnosi termina ed il display visualizza
(fig. 3-21):
A u t o d i a g n o s i
C O M P L E T A T A *
Figura 3-21
3.3 FUNZIONAMENTO
Al termine dell'autodiagnosi (dopo circa 10 secondi), il
display visualizza (fig. 3-22).
P R O N T O
H S
M S
P . O N
A Z
*
Figura 3-22
e l'HeliTest è pronto all'uso, predisposto nelle seguenti
condizioni:
HS = alta
sensibilità
MS
=
modo di misurazione
P.ON = sonda
abilitata
AZ = zero
automatico
Se, entro 1 minuto circa, la sonda non viene estratta
dal suo alloggiamento, l'HeliTest, per evitare un inutile
consumo di energia, si porta in posizione di attesa ed il
display visualizza (fig. 3-23).
L'HeliTest rimane in posizione di attesa per 45 minuti e
poi si spegne automaticamente se nel frattempo non
viene utilizzato.
S T A N
D - B
Y
H S
M S
P . O N
A Z
*
Figura 3-23
In entrambe le condizioni (fig. 3-22 o fig. 3-23), quando
la sonda viene estratta dal suo alloggiamento, il display
visualizza (fig. 3-24) per un tempo compreso tra 5 e 50
secondi:
- - - >
M I S U R A
A T T E N D E R E *
Figura 3-24
Durante i quali viene eseguita un'ulteriore verifica sulla
linea di campionamento, sulla pompa e sul
riscaldatore; in seguito il display visualizza
(fig. 3-25):
❙❙❙❙
. . . . . . . . .
❙❙❙❙
0
p p m
*
Figura 3-25
L'HeliTest è pronto ad operare nel modo di
misurazione. Il display fornisce una lettura tra 0 ppm e
9 x 10
5
ppm; ed il grafico a barre indica il valore della
mantissa. La cifra "0" lampeggia se il segnale diventa
negativo rispetto al valore dello zero impostato.