Valco Cincinnati VCX OT-120 FlexosealPro 2-Corrugated, Руководство пользователя

Страница: 80 / 164

5-13 Valco Cincinnati, Inc.
Section 5 - Operation MC091 - VCX OT-120 FlexosealPro 2 - Corrugated
N o t e s
Configure the Glue Valves -
Continued
Name Use
Scanner Number Displays the number of the scanner that is assigned.
Valve Number Displays the number of the valve that is assigned.
Valve Type Displays the type of valve used. Select type by pressing the up
and down arrows and press on your choice from the list
displayed.
Distance from Valve
to Scanner Displays the distance (in millimeters or inches) between the
valve and the scanner.
Minimum Speed
Threshold The minimum speed the product must reach before glue is
applied.
Minimum Activation
Time (Tmin) The minimum peak valve activation signal (for dot patterns).
Off Compensation
Time (Toff) The amount of time (in ms) that passes from when a valve is
turned off and when it stops applying glue.
On Compensation
Time (Ton) The amount of time (in ms) that passes from when a valve is
activated and it begins to apply glue.
Correction Factor For right angle machines or 2 machines running at different
speeds. The correction factor allows for synchronization.
Confirmation Button Press to enter the new settings. (No settings or values are
entered until this is pressed.)
Cancel Button Cancel the new settings and return to the previous settings.
(Use before pressing the Confirmation Button.)
CAUTION! CAUTION! CAUTION! CAUTION! CAUTION! If using a reversible glue valve station: If using a reversible glue valve station: If using a reversible glue valve station: If using a reversible glue valve station: If using a reversible glue valve station:
When setting the system for Bottom-Up gluing for the first
time, the “Distance from Valve to Scanner“ setting must
be entered manually. This is because the valve order is
physically reversed when the station is inverted.
Activation and compensation times might also require
minor adjustment.
After that initial setup, the system retains the settings in
memory. When the Top-Down/Bottom-Up Switch (Figure
5-16) is used, the settings for the selected configuration
will be applied automatically.