4-1
Valco Cincinnati, Inc.
SECTION 4 - SETUP
SECTION 4 - SETUP
SECTION 4 - SETUP
SECTION 4 - SETUP
SECTION 4 - SETUP
Adding
Modules
Removing the Cover
of the VCX Control
To remove the cover of the VCX Control, use a hex wrench to turn the hex
latches 1/2 turn to unhook the 4 latches that lock the cover onto the base (see
Figure 4-1). Carefully remove the cover by grasping the cover “cup” handle
and lifting the cover off of the unit. Reverse this procedure to replace the
cover.
Figure 4-1. Remove the VCX Control Cover
Latch
Latch
Cover “Cup” Handle
The Power Supply Module is always on the left side of the VCX Control.
Additional modules are added from left to right. Always place the Tracking
Control Module(s) in the slot(s) on the right.
Module choices include Pattern Control Modules (PCM), Inspection Control
Modules (ICM), Tracking Control Modules with Ejector (TCM-E), and Color
Code Reader (CDS).
Warning!
Warning!
Warning!
Warning!
Warning!
Turn off all power and disconnect the power cord to the
VCX Control before adding or removing modules.
FAILURE TO OBSERVE WARNING MAY RESULT IN
DEATH, PERSONAL INJURY, AND/OR EQUIPMENT
DAMAGE.
