5-3
Valco Cincinnati, Inc.
Section 5 - Installation
MC032 - MCP-25 Control
f.
For line-to-neutral operation
For line-to-neutral operation
For line-to-neutral operation
For line-to-neutral operation
For line-to-neutral operation, use the shorting clip
and one fuse or two fuses. (The shorting clip must be
on the left side of the drawer when rotated to the
correct voltage position as shown in Figure 5-1.)
For
For
For
For
For
line-to-line use
line-to-line use
line-to-line use
line-to-line use
line-to-line use,,,,, discard the shorting clip and use two
fuses.
g.
Replace the drawer in the fuseholder in the correct
voltage position and close the door of fuseholder.
h.
Ensure that the correct operating voltage shows
through the window in the fuse drawer.
2.
Connect the power cord:
Connect the power cord:
Connect the power cord:
Connect the power cord:
Connect the power cord:
a.
Insert the power cord into the power-entry module.
b. Attach the power-cord clamp (if provided), using the two
screws on either side of the power-entry module.
Only certain controls have a power-cord
clamp.
c.
Tighten the power-cord clamp to prevent the cord
from working its way out of the module and to
provide strain relief for the line cord.
The supplied power cord can either be
directly wired to a branch circuit or, with
the proper plug type, plugged into an
outlet. The wire colors of the supplied
power cord are as follows:
WARNING!
WARNING!
WARNING!
WARNING!
WARNING!
Setup in step 6 may vary, depending on what country
the system is being installed in. It is the purchaser’s
responsibility to ensure that all local, county, state, and
national codes, regulations, rules, and laws relating to
safety and safe operating conditions are met and
followed. OTHERWISE, DEATH, PERSONAL INJURY,
OR DAMAGE TO EQUIPMENT COULD OCCUR.
Connecting the Main Power Supply
- Continued
Wire Function
International Line-Cord Color
North-American Line-Cord Color
Line Voltage
Brown
Black
Neutral Blue
White
Protective Earth
Green/Yellow
Green
