Vaderstad Rapid RDA 400S, Оригинальное руководство пользователя

Страница: 32 / 138

Instructions and settings
32 27.06.2011
ver. 2
3.10.2 Drilling depth setting using the Interactive DepthControl function (IDC)
The drill is equipped with the Interactive Depth Control feature (IDC), which enables fine adjust-
ment of the drilling depth from the tractor cab while driving. The drilling depth is set according
to ”
3.10.2 Drilling depth setting using the Interactive DepthControl function (IDC)” on page 32
.
For detailed instructions how to set and calibrate the system, see ”
3.31 Interactive Depth Control
function, IDC (option 15582-)” on page 67
.
When using the Interactive Depth Control function, the stop bolt (A) should be set to a “safe drill-
ing depth”, i.e. the maximum desired depth, see ”
Figure 3.25 ” on page 31
.
Reset and bleed the system for about 5 seconds a couple of times throughout the work day. Refer
to
”4.1 Sowing depth” on page 84
.
If the Control Station has not been programmed for the Interactive Depth Control function, then
the drilling depth can be manually adjusted by setting the stop bolt (A) in the desired position. The
scale indications do not constitute absolute values of the drilling depth in centimetres, but serve
as an index only, see ”
3.10.3 Manual adjustment of sowing depth” on page 33
.
!
In order to use the Interactive Depth Control function, the Control Station must be loaded with
firmware version 210004 or later.
The Interactive Depth Control function allows setting and fine adjustment of the drilling depth
from the Control Station. An ultrasonic sensor measures the lifting ram position, while two hy-
draulic electric valves determine the drilling depth and the low-lift position.
The machine is raised and lowered in the usual fashion using the hydraulic levers on the tractor.
To engage the Interactive Depth Control function, depress the button.
When this function is engaged, the indicator lamp in the button blinks, the alarm indicator
blinks and a buzzer sounds.
The position of the lifting ram can now be fine adjusted using the hydraulic levers on the tractor.
The ram operates at a reduced speed selected in the calibration menu. See ”
3.31.2 Calibration
menu” on page 68
.
The drilling depth scale value is displayed next to the symbol. See “Figure 3.26”. The scale
value is not an exact depth in centimetres but rather serves as a reference.
Figure 3.26 Figure 3.27