UTT Technologies
Chapter 11 System Administration
http://www.uttglobal.com
Page
142142
10.5 Remote Access
This section describes the
Administration > Remote Access
page. In this page, you can
enable HTTP remote management, which allows you to access the Gigabit Router’s Web
UI from anywhere over the Internet.
Figure 10-9 Remote Access Settings
Enable HTTP:
It allows you to enable or disable HTTP remote management. Select
this check box to enable HTTP remote management. To access the Gigabit Router’s
Web UI over the Internet, you should enter
http://
and the Gigabit Router's WAN IP
address, followed by a colon and the port number. For example, if the WAN IP
address is 218.21.31.3 and port number is 8081, please enter
http://218.21.31.3:8081
in your browser’s address bar.
Remote Management Port:
It specifies the port number that will be open to outside
access. The default value is 8081.
Interface:
It specifies the interface on which the HTTP remote management is
enabled. Here you can select only one interface. To enable HTTP remote
management on multiple interfaces at the same time, you need to go to the
Advanced > NAT&DMZ > Port Forwarding
page to create port forwarding entry(s)
for the other interface(s).
Save:
Click to save your changes.
Cancel:
Click to revert to the last saved settings.
Note
1. To ensure security, it is strongly recommended that you don’t enable HTTP remote
management unless necessary.
2. After you enable the HTTP remote management, the system will automatically create
a port forwarding entry whose name is
admin
. You can go to the
Advanced >
NAT&DMZ > Port Forwarding
page to view it in the
Port Forwarding List
.
