Universal Devices ISY-994i Series, Руководство пользователя

Страница: 440 / 692

Page | 417
•
From the Admin Console, Select Z-Wave -> Replicate (Learn Mode) and wait for a
popup window to appear.
o
If the popup window does not appear, select 'Stop Adding or Removing a Z-
Wave Device' from the advanced menu then try again.
•
Use the instructions for your Primary Controller to add a new Z-Wave device (the
ISY) to the network, and optionally shift Primary control to the ISY.
•
Wait until the transfer is complete; the instructions for your Primary Controller
should tell you what to look for (e.g. LEDs stop flashing, it beeps, etc.)
o
The popup window will go away, and you will see the new Z-Wave devices
appear in the ISY device tree
Adding Devices directly from ISY
•
Make sure the ISY is the Primary Controller
•
Select Add a Z-Wave Device from the menu and wait for a popup window to
appear.
o
If the popup window does not appear, select 'Stop Adding or Removing a Z-
Wave Device' from the advanced menu then try again.
•
Put the Z-Wave device in link mode. Refer to the user guide for your product on how
to do this. In many cases, this just requires you to press a button on the device.
•
The ISY will begin adding the device (this may occur a few seconds after you put the
device in link mode)
o
The popup window will go away, and you will see your device added to the
tree.
Note
•
All Secure devices such as door locks must be added to the ISY directly
15.1.18 Adding/Removing Devices Using Another Controller
•
Shift Primary Control to the controller you want to use for including new Z-Wave
devices into the network
•
Add/Remove devices using the controller
•
Either Shift Primary Control back to the ISY, or update the information in ISY
15.1.19 Shift Primary Control to ISY
•
From the Admin Console, Select Z-Wave -> Replicate (Learn Mode)
•
Use the instructions for your Primary Controller to start Replication that shifts
Primary Control to another device.
•
Wait until the transfer is complete; the instructions for your Primary Controller
should tell you what to look for (e.g. LEDs stop flashing, it beeps, etc.)
•
You should start seeing the Z-Wave devices appear in the ISY device tree