14
Fill the gearbox with the oil provided as shown. The
en2re boGle (70ml) must be emp2ed into the gearbox.
The gearbox oil will need to be topped up periodically.
Before topping up, remove the ‘Oil Level Screw’ and
pour in the oil un2l it just starts to run out the screw
hole and then immediately replace the screw.
PLACING OIL IN THE GEARBOX
It is important that the gearbox be filled with oil before
commissioning the operator.
Only use SAE75W-90 oil to refill.
Oil Level Screw
Oil Plug
1. Push the gate to the fully closed posi2on.
2. Place the magnet on the rack, 600mm from the centre of the motor .
3. Using the self drilling TEK screw and washer, aGach the magnet to the rack.
4. The space between the lid and the magnet must not exceed 3mm. If it does, place washers behind the mag-
net to reduce the space.
Do not invert the magnet. Only use the magnet supplied with the operator.
MOUNTING THE MARKER MAGNET
600mm
3mm
Содержание HT18/36
