Tuttnauer LabSci 11-V, Руководство по эксплуатации и обслуживанию

Страница: 82 / 97

Page 81
The door is equipped with an electrical cylinder. This electrical
cylinder performs the automatic opening and closing of the door.
10.3 Opening the door
1. Place your thumb on the plastic door cover and the other fingers in the
handle.
2. Pull the handle until the locking of the door is released.
3. Open the door.
When the door is open, the door open sign is displayed.
10.4 Loading
•
Load the autoclave properly according to instructions in sec. 9.
PREPARATION BEFORE STERILIZATION.
•
Select the program.
▪
UP key: next program.
▪
DOWN key: previous program.
•
Verify that you chose the required program.
10.5 Closing the door
1. Hold the opening handle in open position, while pushing the door until
it comes to closed position, then release the handle.
2. The open-door symbol is replaced by the message "System
Ready".
10.6 Starting cycle
If your autoclave is WR configuration, for the first cycle, fill the mineral
-free water reservoir. If "Supplied Distilled Water Error" message
appears between the cycles, add water to the reservoir until the
message disappears. Do not fill the reservoir completely!
•
Start the cycle by pressing the START/STOP key.