The following entries are displayed on this screen:
Static Mroute Config
Source:
Enter the IP address that identifies the multicast source of
the entry you are creating.
Source Mask:
Enter the subnet mask to be applied to the Source.
RPF Neighbor:
Enter the IP address of the neighbor router on the path to
the mroute source.
Distance:
Enter the Administrative distance of static mroute. The
range is 0-255 and default is 0. The lower the distance, the
better the preference.
Static Mroute Config Table
Select
：
Select the static mroute entry to modify.
Source:
Displays the IP address of the multicast source.
Source Mask:
Displays the subnet mask of source.
RPF Neighbor:
Displays the IP address of the neighbor router.
Distance:
Displays the Administrative distance of static mroute.
Click
delete
to delete the selected entry.
11.5.2
Application Example for Static Mroute
Network Requirements
1.
The network runs PIM DM and all the switches in the network support multicast features.
2.
Switch A, Switch B and Switch C run OSPF protocol.
3.
In normal circumstances, Receiver receives multicast data from Source through the path
Switch A-Switch B, which is the same as the unicast route.
4.
After the configuration takes effect, Receiver will receive multicast data from Source
through the path Switch A-Switch C-Switch B.
293
Содержание T3700G-28TQ
Страница 1: ...User Guide T3700G 28TQ T3700G 52TQ 1910012358 REV3 0 0 November 2018...
Страница 11: ...XI...
