TP-Link T3700G-28TQ, Руководство пользователя

Страница: 212 / 430

Key ID: Enter the RIP Authentication Key ID for the specified
interface. If you choose not to use authentication or to use
'simple' you will not be prompted to enter the key ID.
Key: Enter the RIP Authentication Key for the specified interface.
If you do not choose to use authentication you will not be
prompted to enter a key. If you choose 'simple' or 'MD5' the
key may be up to 16 octets long.
10.8.3
Application Example for RIP

Network Requirements

IP addresses of Switch A's three interfaces are 1.1.1.1/24, 2.1.1.1/24, 3.1.1.1/24 respectively.
IP addresses of Switch B's three interfaces are 1.1.1.2/24, 10.1.1.1/24, 11.1.1.1/24
respectively.

RIP is required to be enabled in all interfaces of Switch A and B. Network shall be
interconnected between Switch A and B with the use of RIPv2.

Network Diagram

Configuration Procedure

Configure Switch A
Step Operation Note
1 Enable RIP Required. On page Routing → RIP → Basic Config , enable RIP,
select RIPv2 as RIP version.
2 Enable the network
segments where
the interfaces are
located Required. On page Routing → RIP → Basic Config Network Enable
part, add network segments 1.1.1.0, 2.1.1.0, 3.1.1.0, and enable
RIP in these network segments. These network segments will be
displayed in RIP Network List after they are successfully added.

Configure Switch B
Step Operation Note
1 Enable RIP Required. On page Routing → RIP → Basic Config , enable RIP,
select RIPv2 as RIP version.
2 Enable the network
segments where
the interfaces are
located Required. On page Routing → RIP → Basic Config Network Enable
part, add network segments 1.1.1.0, 10.1.1.0, 11.1.1.0, and enable
RIP in these network segments. These network segments will be
displayed in RIP Network List after they are successfully added.
201