TP-Link T3700G-28TQ, Руководство пользователя

Страница: 263 / 430

Configuration Procedure
：
Steps Operation Note
1 Configure
interface and
its IP address.
Required. On page Routing → Interface → Interface Config , create
a routing interface (either interface VLAN or routed port) and specify
its IP address and subnet mask.
2 Add port to the
interface.
Required. On page VLAN → 802.1Q VLAN → VLAN Config , add the
port connected to the client to the interface VLAN configured in
Step 1.
3 Configure VRID
and Virtual IP.
Required. On page Routing → VRRP → Basic Config , configure a
VRID and Virtual IP for the interface in Step 1. The Virtual IP and the
interface IP should be on the same LAN. The client should configure
this Virtual IP as the default gateway.
4 Configure the
priority.
Optional. On page Routing → VRRP → Advanced Config , configure
the priority value to be used by the VRRP router in the election for
the master Virtual Router.
5 Configure the
Authentication
Type.
Optional. On page Routing → VRRP → Advanced Config , configure
the authentication type for the Virtual Router.
10.10.6
Application Example for VRRP

Network Requirements
1. Host A needs to access Host B on the Internet. The default gateway of Host A is
192.168.1.10/24.
2. Switch A and Switch B are in the backup group with the Virtual IP address as
192.168.1.10/24.
3. When Switch A works normally, packets sent from Host A to Host B are forwarded by
Switch A. When Switch A is down, packets sent from Host A to Host B are forwarded by
Switch B.
252