TP-Link T3700G-28TQ, Руководство пользователя

Страница: 250 / 430

2 Create OSPF
process
Required. On page Routing →OSPF→ Process , Create OPSF process
1 and configure the Router ID as 2.2.2.2.
3 Create
networks in the
area
Required. On page Routing →OSPF→ Network , configure network
1.10.1.0/24 in area 0 and configure network 1.30.1.0/24 in area 2.
4 Configure area
aggregation
Optional. On page Routing →OSPF→Area Aggragation , configure
the aggregation address as 1.30.0.0/16 in area 2.

Configure Switch C
Step Operation Description
1 Create routing
interfaces and
their IP
addresses
Required. On page Routing →Interface→ Interface Config , create
routed port 1/0/1 with the IP 1.20.2.1/24 and routed port 1/0/2 with
the IP 1.20.1.2/24.
2 Create OSPF
process
Required. On page Routing →OSPF→ Process , Create OPSF process
1 and configure the Router ID as 3.3.3.3.
3 Create
networks in the
area
Required. On page Routing →OSPF→ Network , configure network
1.20.0.0/16 in area 1.

Configure Switch D
Step Operation Description
1 Create routing
interfaces and
their IP
addresses
Required. On page Routing →Interface→ Interface Config , create
routed port 1/0/1 with the IP 1.30.2.1/24 and routed port 1/0/2 with
the IP 1.30.1.2/24.
2 Create OSPF
process
Required. On page Routing →OSPF→ Process , Create OPSF process
2 and configure the Router ID as 4.4.4.4.
3 Create
networks in the
area
Required. On page Routing →OSPF→ Network , configure network
1.30.0.0/16 in area 2.
10.10
VRRP
VRRP (Virtual Router Redundancy Protocol) is a fault-tolerant protocol. Generally, all hosts in a
LAN (Local Area Network) would set a default route. Packets which are sent by the host and
whose destination address does not belong to the local network segment will be sent to the
gateway via the default route. Therefore, communication between the host and external
network can be established. Once the gateway fails, all hosts of this network segment whose
default next hop is the gateway will stop communicating with external network.
239