Toshiba Strata CTX, Руководство по программированию

Страница: 519 / 533

Software and Firmware Updates
IP Telephone/BIPU Firmware Update Procedures
Strata CTX Programming - Part 4: Appendices 04/03
E-3
Soft
w
a
re
a
nd F
irm
wa
re
Upda
tes
9. After the update is complete, select BIPU Configuration, and check the BIUP version numbers to verify
they have been updated properly.
10. Select Maintenance > Components > Cabinet. Enable the BIPU cabinet slot that supports updated IP
telephones. All IP telephones connected to this BIPU should be idle and functioning.
IP Telephone Update
Important! Complete all “Prerequisites” on page E-1 before you do the following.
➤
From the WinAdmin PC or External SmartMedia read\write device
1. Store the update files on the SM card.
2. “Force format” a SmartMedia card using WinAdmin
3. Copy the DIPXXXX update file under the SmartMedia card PROGRAM folder (XXXX is the IP
Telephone firmware version level).
➤
From the WinAdmin PC perform the update
1. Select Operations > SmartMedia. Check that the DIPXXXX file is stored on the SM card under the
PROGRAM directory.
2. Select Maintenance > Components > Cabinet.
3. Force Disable the BIPU cabinet slot that supports IP telephones to be updated.
4. All IP telephones connected to this BIPU should in the Make Busy mode.
5. Select IP Telephone > IPT Program Update. Select the IPT PDN to be updated.
6. Select CTX Internal (SmartMedia) radio button.
7. An ftp Name and Password is inserted automatically.
8. The IP address of the CTX processor (SM card) is inserted automatically.
9. From Data Directory box enter: PROGRAM
10. From File Name box enter: DIPXXXX
11. Click Start and observe the update status: Getting Updated file\Updating\Finished
Updating\Resetting\idle.
Notes
• It could take 30 seconds to 2 minutes to update the IP telephone.
• If an error occurs, recheck file names, locations etc. and try again.
12. Select IP telephone > Station Data, check the IPT version number to verify that all IPTs have been
updated properly.
13. Select Maintenance > Components > Cabinet. Enable the BIPU cabinet slot that supports updated IP
telephones.
All IP telephones connected to this BIPU should be idle and functioning.
➤
To check the IP telephone firmware version directly from an IP telephone
1. Simultaneously press
+ROG
buttons on the IP Telephone.
2. At the SELECT = prompt, press then press
+ROG
.
3. At the Select function key prompt, press
)%
, the IP telephone will be displayed.
Notes
• The WinAdmin PC cannot be connected directly to the CTX processor network jack.
• All connections must be through the network.