Toshiba e-STUDIO 20CP, Руководство по обслуживанию

Страница: 181 / 323

3-20
Service Manual
5060-XXX
Once the sensors have been polled the following will be displayed and the sensors are
ready to test:
Media Level
S1=CL S2=CL
S1= S2=
Once the screen is displayed you can manually actuate the sensor. When the sensor is
closed CL is displayed, when the sensor is open OP will be displayed.
To exit the sensor test, press RETURN or STOP.
Hole Punch Test
Use this test to verify that media can be fed to the Finisher output bin and hole punched.
No information is printed on the feed test pages since the laser is not energized during
this test. Eight sheets of paper are fed and holes punched with a three hole pattern.
Enter the Diagnostic mode.
4.
Select Finisher Tests from the menu.
5.
Select Hole Punch Test.
Press Return after the test is complete to exit the test.
Miscellaneous Tests
Automated Motor Detection
This test initiates an Automated Motor Detection. It must be performed if the NVRAM
contents are erased such as when a RIP or engine board has been replaced. This test
must be performed anytime the ITU motor, Fuser motor, or Cartridge drive motors are
replaced.
To run the Miscellaneous Tests:
1.
Select Misc. Tests from the menu.
2.
Select Motor Detect from the menu.
3.
Remove all the print cartridges from the printer.
4.
Press Go.
The following screen is displayed:
Motor Detection in progress
The test lasts approximately ten seconds. No buttons are active during detection and the
test completes automatically.