Toshiba Carrier MMC-AP0181H2UL, Руководство по обслуживанию

Страница: 134 / 178

134
No.
11
Part name
Heat
exchanger
Procedure
1. Detachment
1) Recover the refrigerating gas.
2) Remove the refrigerant pipe at the
indoor unit side.
3) Perform the detachment work in
9
.
Remove also the sensors.
4) Take off screws which fix the piping
cover and then remove the piping cover.
(Ø4 x 0.31"(8mm), 2 pcs.))
5) When replacing the PMV motor, peel off
butyl rubber stuck on the PMV main unit
until PMV main unit can become visible,
loosen the nuts which fix the PMV motor
and then remove the PMV motor.
6) Take off screws of the heat exchanger
support while holding the heat exchanger
and then remove the heat exchanger
support. (Ø4 x 0.31"(8mm), 4 pcs.)) side at
opposite side of the heat exchanger
7) Take off screws of the heat exchanger at
the opposite side of the heat exchanger
support while holding the heat exchanger
and then remove the heat exchanger.
(Ø4 x 0.31"(8mm), 2 pcs.))
2. Attachment
1) Fix the heat exchanger, sensors and
piping cover as before.
2) Perform the work procedure 2)-
9
.
3) Connect wire of the refrigerant as before
and then perform vacuuming.
Remarks
1. Detachment
1) Carry out work of Detachment of
10
.
2) Remove the set screws (2 positions) of
fixing vertical grille.
3) Remove the vertical grille.
2. Attachment
1) Using screws, mount the vertical grille as
before.
2) Carry out work of Attachment of
10
.
Vertical grille
12
Screw Screw
Screws
PMV motor
Heat exchanger support Heat exchanger support Heat exchanger support
Screw
PMV main unit
PMV main unit PMV main unit PMV main unit
Vertical grille
Screws
(Fixing drain pan and vertical grille)