Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Maintenance Safety
•
Before you leave the operator’s position, do the
following:
– Park the machine on a level surface.
– Disengage the power takeoff and lower the
attachments.
– Engage the parking brake.
– Shut off the engine and remove the key (if
equipped).
– Wait for all movement to stop.
•
Allow machine components to cool before
performing maintenance.
•
If the cutting units are in the transport position, use
the positive mechanical lock (if equipped) before
you leave the machine unattended.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Support the machine with jack stands whenever
you work under the machine.
•
Carefully release pressure from components with
stored energy.
•
Keep all parts of the machine in good working
condition and all hardware tightened, especially
blade-attachment hardware.
•
Replace all worn or damaged decals.
•
To ensure safe, optimal performance of the
machine, use only genuine Toro replacement
parts. Replacement parts made by other
manufacturers could be dangerous, and such use
could void the product warranty.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first hour
• Torque the wheel-lug nuts to 94 to 122 N∙m (70 to 90 ft-lb).
After the first 10 hours
• Torque the wheel-lug nuts to 94 to 122 N∙m (70 to 90 ft-lb).
• Check the alternator-belt tension.
After the first 50 hours
• Change the engine oil and filter.
Before each use or daily
• Check the tire pressure.
• Check the operation of the safety-interlock switches.
• Check the blade stopping time.
• Check the engine-oil level.
• Drain water or other contaminants from the water separator.
• Check the level of coolant in the expansion tank and clean debris off the screen, oil
cooler, and front of the radiator.
• Remove debris from the screen and radiator/oil cooler (more frequently in dirty
operating conditions).
• Check the hydraulic fluid level.
• Check the hydraulic lines and hoses for leaks, kinked lines, loose mounting supports,
wear, loose fittings, weather deterioration, and chemical deterioration.
• Clean the machine.
• Clean and maintain the seatbelt.
Every 50 hours
• Grease the bearings and bushings (immediately after every washing regardless of
the interval listed).
• Check the condition of and clean the battery.
• Check the battery cable connections.
Every 100 hours
• Inspect the cooling system hoses.
• Check the alternator-belt tension.
Every 250 hours
• Torque the wheel-lug nuts to 94 to 122 N∙m (70 to 90 ft-lb).
• Change the engine oil and filter.
50
Содержание Groundsmaster 4300-D
