Toro Groundsmaster 4300-D, Руководство оператора

Страница: 28 / 80

Checking the Engine-Oil
Level
Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
Checking the Engine-Oil Level (page 56) .
Checking the Cooling
System
Before you start the engine and use the machine,
check the cooling system; refer to
Checking the
Cooling System (page 28) .
Checking the Hydraulic
System
Before you start the engine and use the machine,
check the hydraulic system; refer to
Servicing the
Hydraulic Fluid (page 66) .
Draining the Water
Separator
Drain water or other contaminants from the water
separator; refer to
Draining the Water Separator (page
28) .
Checking the Tire Pressure
Service Interval: Before each use or daily
The correct air pressure in the front and rear tires is
83 to 103 kPa (12 to 15 psi).
Important:
Maintain pressure in all tires to
ensure a good quality of cut and proper machine
performance.
Do not under-inflate the tires.
Check the air pressure in all the tires before
operating the machine.
g001055
Figure 21
Checking the Torque of the
Wheel-Lug Nuts
Service Interval: After the first hour
After the first 10 hours
Every 250 hours
WARNING
Failure to maintain the proper torque of the
wheel nuts could result in failure or loss of a
wheel, and may result in personal injury.
Torque the front and rear-wheel nuts to 94 to
122 N·m (70 to 90 ft-lb) at the recommended
service intervals.
28