Toro Groundsmaster 4300-D, Руководство оператора

Страница: 53 / 80

Pre-Maintenance
Procedures
Raising the Machine
Use the following as points to jack up the machine:
•
Front of the machine —rectangular pad, under
the axle tube, inside each front tire ( Figure 64 ).
g031850
Figure 64
1. Front jacking point
•
Rear of the machine —rectangular axle tube on
the rear axle.
Lubrication
Greasing the Bearings and
Bushings
If you operate the machine under normal conditions,
use No. 2 lithium grease to lubricate all bearings
and bushings at the specified maintenance interval.
Lubricate bearings and bushings
immediately after
every washing, regardless of the interval listed.
The grease fitting locations and quantities are as
follows:
•
Pump driveshaft U-joint (3)— Figure 65
g003962
Figure 65
•
Cutting unit lift-arm cylinders (2 each)— Figure 66
g011612
Figure 66
•
Lift-arm pivots (1 each)— Figure 66
53