Protos 3 - Chromogenic ID - Batch set-up
Quick Guide
3
1
2
Position plate
6
Click New Batch
Click
Choose batch type
Select
Select Chromogenic Media
1
Start Protos 3 software
Run Protos 3
Click
Insert the plate holder, ensuring the
plate holder which is recommended by
the software is used
Place plate onto plate holder
5
Defaults are Circular plate 90mm
Change if necessary
Plate configuration
Click
Create batch
4
Enter a Plate ID
Enter
Enter a plate ID found on Measure
tab. Autoincrement default is “on”, to
change this click on the Configuration
tab
Click