VividLeds VEGA2 ALD, Инструкции

Страница: 1 / 2

VEGA2 ALD
INSTRUCTIONS
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
I MPORTANT INSTALLATION INFORMATION
1.Before commencing installation or maintenance, ensure
electricity is switched off at the mains. Installation or
maintenance should be carried out by a qualified electrician.
2.The lu minaire must not, under any circumstances, be
installed directly to flammable materials, and I uminai res
must not be covered with any flammable materia Is.
3.Mounting height range of6 to 12 meters, this model is
suitable for outdoor lighting.
4.Ensure there is adequate free air circulation of at least
50cm around the luminaire.All luminaires run hot. It is
the installer's responsibility to consider fire risk and take
appropriate precautions.
LEAVE A COPY FOR THE USER/ MAINTENANCE ENGINEER
FOR FUTURE REFERENCE
Installation Instruction & Installation Steps
0
U-bracket
U-bracket
STEP 1:
Unsc.-ew screws from the yoke mounting bracket using an Allen .
See Figure 1.
8
STEP 3:
Fit lightbody into th e hooks of U-bracket, and make sure the
locking washers must be locate cl between U bracket the lightbody.
See Figure 3.
e
STEPS:
U-bracket
locking screws
loosen the
screws
on both sides of U bracket, rotate the light body
to a specific aiming direction for illumination, finally lock the screws
at 45 N .m torque to complete installation.
e
U-bracket
�\
STEP 2:
�
1 ____ w ___ .... 1-
[�
� »<''• orn<"e,
•
mounting surface
Mains power supply
Get
the mains power supply cord through wiring hole on U bracket, then
fix
U
bracket to
tacade
or other location using swelling bolts or other screws.
See Figure 2
0
Junction Box
STEP4:
Tighten the screws slightly, rotate the light body and make it easier for wirin g,
then connect mains power supply to the power cord of lightbody,
See Figure 4.
For more details about wiring, please refer to the wiring instruction
to compete wiring, see Figure 6.