Toro 34215, Руководство оператора

Страница: 32 / 80

g027123
Figure 33
1. Deflector-gate control 5. Narrow-spreader
distribution flow-rate
knob
2. Spreader-pattern control 6. Impeller On/Off switch
3. Wide-distribution
impeller-gate lever 7. Impeller-speed control
4. Narrow-distribution
impeller-gate lever
3. Move the throttle to the F
AST
position and drive
the machine forward.
4. Open the either the narrow or wide impeller-gate
lever to begin spreading (
Figure 34 ).
Note:
Use the narrow-spreader distribution
flow-rate knob to control the discharge rate
of the granular material from the hopper onto
the impeller when the narrow-distribution
impeller-gate lever is in the O
PEN
position.
g027497
Figure 34
1. Wide spreader
pattern—variable effective
width to 6.7 m (22 ft)
maximum 2. Narrow spreader
pattern—variable effective
width from 1.5 m (5 ft)
minimum
5. Evaluate the spread pattern.
Note:
If you need to adjustment the spreading
pattern, refer to Adjusting the Spreader Pattern
(page 30) .
6. When you are finished spreading, close the
wide-distribution impeller-gate lever.
Note:
Only the wide-distribution impeller-gate
lever closes the impeller gate. Pushing the
wide-distribution impeller-gate lever forward also
resets the narrow-distribution impeller-gate lever
to the forward position.
7. Clean the hopper after each spreading session;
refer to
Cleaning and Lubricating the Spreader
(page 43) .
Important:
Always empty and clean the
spreader immediately after each use. Failure
to do so may cause the chemicals to corrode
the spreader and other components.
32