Toro 34215, Руководство оператора

Страница: 41 / 80

Spraying Tips
g027300
Figure 45
1. Overlap area—narrow spray pattern 6. Sprayer Off—do not spray when turning the machine 180°
2. Effective spray area 7. End of spraying job
3. Forward 8. Property fence
4. Overlap area—wide spray pattern 9. Gate
5. 2.4 m (8 ft)
•
Do not overlap the effective spray area that you
have previously sprayed (see
Figure 45 ).
•
Watch for plugged sprayer nozzles.
•
Move the narrow-and wide-spray pattern levers
to the O
FF
position to stop the spray flow before
stopping the motion of the machine. Once
stopped, leave the motion-control lever in N
EUTRAL
and leave the sprayer-pump switch in the O
N
position.
•
You obtain better results if the machine is moving
when spray controls are turned O
N
.
•
Ensure adequate pump pressure for proper spray
distribution by push forward the tank-agitation
lever to the
OFF
position.
•
Watch for changes in the application rate.
Changes in the application rate indicate that your
ground speed has changed beyond the operating
range of the nozzles or there is a problem with the
sprayer system.
Note:
When the tank is nearly empty, the tank
agitation may cause foaming of the chemical solution
in the tank. In this case, push forward the tank
agitation lever to the
OFF
position. Alternatively, if
an anti-foaming agent compatible with the existing
chemical—add the anti-foaming agent according to
the manufacturer’s instructions.
41