Toro 34215, Руководство оператора

Страница: 73 / 80

Problem Possible Cause Corrective Action
1. The impeller is dirty or damaged. 1. Clean, repair, or replace the impeller.
2. The spreader-pattern control is not
adjusted properly.
2. Adjust the spreader-pattern control;
refer to the Adjust the Spreader Pattern
procedure in the Using the Spreader
section.
3. The sprayer nozzles are clogged. 3. Clean or replace the nozzles.
4. The hopper screen is plugged. 4. Clean the hopper screen.
5. Material in the hopper is clumped over
the gate.
5. Check to see if the agitator pin for the
shaft of the impeller motor is present.
The spreader or sprayer pattern is uneven.
6. The diffuser ramp setting is incorrect. 6. Adjust the position of the control cable.
1. The sprayer tank is empty. 1. Fill the sprayer tank.
2. The sprayer-pump supply valve is
closed or partially closed.
2. Fully open the sprayer-pump supply
valve.
3. The strainer is clogged or damaged. 3. Clean, repair, or replace the strainer.
4. The pump is clogged or damaged. 4. Clean, repair, or replace the pump.
5. The nozzles are clogged. 5. Clean or replace the nozzles.
6. The hoses are clogged, kinked, or
damaged.
6. Clean, repair, or replace the hoses.
7. The tank-agitation lever is in the O
N
position.
7. Move the tank-agitation lever to the
O
FF
position.
8. The sprayer-pattern lever is not in the
O
N
position.
8. Move the narrow- or wide-sprayer
pattern lever to the O
N
position.
9. The sprayer pressure and ground
speed are incorrect.
9. Adjust the sprayer pressure and the
ground speed of the machine.
10. The chemical mixture in the sprayer
tank is incorrect.
10. Follow chemical manufacturer’s
recommendation.
There is no spray from the sprayer nozzles
in the boom or the nozzles have poor
output.
11. The spray system is leaking. 11. Inspect the components of the sprayer
system; clean, repair, or replace
the sprayer- system components as
needed.
1. Hopper screen is plugged. 1. Clean hopper screen. No material dispensed from hopper.
2. Gate not adjusted properly. 2. Adjust the gate. See Spreader Pattern
Adjustment section in Operation.
1. The sprayer tank is empty. 1. Fill the sprayer tank.
2. The sprayer-wand-pressure control is
in the wrong position.
2. Rotate the pressure control to the
O
PEN
position.
3. The wand is clogged or damaged. 3. Clean, repair, or replace the wand.
4. The spray nozzle for the wand is
clogged.
4. Clean or replace the nozzle.
5. The trigger is not pressed. 5. Press the trigger.
6. The hose is clogged or damaged. 6. Clean, repair, or replace the hoses.
7. The hose is not connected to the wand. 7. Connect the hose to the wand.
The spray wand does not work.
8. The hose for the wand is kinked. 8. Straighten the kink in the hose.
73