Toro 34215, Руководство оператора

Страница: 42 / 80

Spraying with the Spray Wand
WARNING
The spray wand traps liquids under
high pressure, even when engine is off.
High-pressure spray discharge could cause
serious injury or death.
• Keep clear of the nozzle and do not direct
the spray or stream from the wand at
people, pets, or non-work area property.
• Do not direct the spray at or near
electrical-power components or source.
• Do not repair the spray wand, hoses, seals,
nozzle, or other wand components; always
replace them.
• Do not attach the hoses or other
components to the nozzle at the end of the
spray wand.
• Do not attempt to disconnect the spray
wand from the machine while the sprayer
system is pressurized.
• Do not use the spray wand if trigger lock is
damaged or missing.
• Rotate the spray-wand lock to the O
FF
position when job is complete.
1. Remove the wand from the holder at the right
side of the machine (
Figure 46 ).
g033506
Figure 46
1. Wand holder 4. Wand
2. Trigger 5. Nozzle
3. Trigger lock
2. Firmly grip the spray wand and point it in the
direction that you will spray.
Note:
The wand may recoil; ensure that you
hold it securely.
3. Adjust the pump pressure to the spray wand
perform the following:
•
To increase the pump pressure to the
wand, rotate the wand-pressure control
counterclockwise (
Figure 47 ).
g027401
Figure 47
1. Sprayer wand pressure control
•
To decrease pressure to the wand, rotate the
control clockwise direction (
Figure 47 ).
•
To shut off the pressure to the wand, rotate
the wand-pressure control clockwise until the
valve for the control is closed (
Figure 47 ).
4. Squeeze the trigger to the spray-wand handle
to begin spraying; lock the trigger in place if
desired (
Figure 46 ).
5. When finished spraying, if you locked the trigger
of the spray-wand—unlock it, and release the
trigger (
Figure 46 )
6. Rotate the sprayer-wand pressure control
clockwise to the O
FF
position ( Figure 47 ).
7. Insert the wand into the wand holder ( Figure 46 ).
42