Toro 34215, Руководство оператора

Страница: 17 / 80

Verify that there is an adequate supply of clean water
and soap nearby, and immediately wash off any
chemicals that contact you.
•
Carefully read and follow the chemical warning
labels and material safety data sheets (MSDS) for
all chemicals used, and protect yourself according
to the chemical manufacturer's recommendations.
•
Always protect your body while using chemicals.
Use the appropriate personal protective equipment
(PPE) to guard against contact with chemicals,
such as the following:
– safety glasses, goggles, and/or face shield
– a chemical suit
– a respirator or filter mask
– chemical-resistant gloves
– rubber boots or other substantial footwear
– a clean change of clothes, soap, and
disposable towels for cleanup
•
Obtain proper training before using or handling
chemicals.
•
Use the correct chemical for the job.
•
Follow the chemical manufacturer's instructions for
the safely applying the chemical. Do not exceed
the recommended system application pressure.
•
Do not fill, calibrate, or clean the machine while
people, especially children, or pets are in the area.
•
Handle chemicals in a well-ventilated area.
•
Have clean water available, especially when filling
the spray tank.
•
Do not eat, drink, or smoke while working near
chemicals.
•
Do not clean spray nozzles by blowing through
them or placing them in your mouth.
•
Always wash your hands and other exposed areas
as soon as possible after working with chemicals.
•
Keep chemicals in their original packages and
stored in a safe location.
•
Properly dispose of unused chemicals and
chemical containers as instructed by the chemical
manufacturer and your local codes.
•
Chemicals and fumes are dangerous; never enter
the tank or place your head over or in the opening
of a tank.
•
Follow all local, state, and federal regulations for
spreading or spraying chemicals.
Fuel Safety
•
Use extreme care in handling fuel. It is flammable
and its vapors are explosive.
•
Extinguish all cigarettes, cigars, pipes, and other
sources of ignition.
•
Use only an approved fuel container.
•
Do not remove the fuel cap or fill the fuel tank
while the engine is running or hot.
•
Do not add or drain the fuel in an enclosed space.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.
•
If you spill fuel, do not attempt to start the engine;
avoid creating any source of ignition until the fuel
vapors have dissipated.
Performing Daily
Maintenance
Before starting the machine each day, perform the
following daily-check procedures:
•
Checking the Engine-Oil Level (page 52)
•
Checking the Safety Interlock System (page 17)
•
Checking the Machine for Loose Hardware (page
67)
Checking the Safety
Interlock System
Service Interval: Before each use or daily
CAUTION
If interlock switch is disconnected or damaged
the machine could operate unexpectedly
causing personal injury.
• Do not tamper with the interlock switch.
• Check the operation of the interlock switch
daily and replace damaged switch before
operating the machine.
Important:
Ensure that the safety mechanisms
on your machine are connected and in proper
operating condition prior to operating your
machine.
The safety interlock system is designed to prevent the
engine from starting unless you engage the parking
brake.
17