Toro 34215, Руководство оператора

Страница: 22 / 80

4. If the engine is cold, pull up the choke control to
the O
N
position; refer to Choke Control (page
12) .
Note:
If the engine is warm , push down the
choke lever to the O
FF
position.
5. Rotate the ignition switch to the S
TART
position;
refer to Ignition Switch (page 12) .
Note:
When the engine starts, release the
switch.
Important:
Do not crank the engine
continuously for more than 10 seconds at a
time. If the engine does not start, allow a 60
second cool-down period between starting
attempts. Failure to follow these guidelines
can overheat the starter motor
6. If the choke control is in the O
N
position,
gradually move the lever down, toward the O
FF
position as the engine warms up.
Shutting Off the Engine
1. Move the steering-control/motion-control lever
to the N
EUTRAL
position and bring the machine
to a full stop; refer to Steering Control (page 11)
and Motion-Control Lever (page 11) .
2. Place the throttle in the midway between the
S
LOW
and F
AST
positions; refer to Throttle
Control (page 12) .
3. Run the engine for a minimum of 15 seconds,
then turn the ignition switch to the O
FF
position;
refer to Ignition Switch (page 12) .
4. Engage the parking brake; refer to Parking-Brake
Lever (page 12) .
5. Remove the key; refer to Ignition Switch (page
12) .
6. Close the fuel-shutoff valve when you are
not using the machine for a few days, when
transporting it, or when it is parked inside a
building; refer to
Opening and Closing the
Fuel-Shut-Off Valve (page 21) .
Driving the Machine
CAUTION
Machine can turn rapidly by moving the
steering control to the far right or left.
Operator may lose control of the machine,
which may cause damage to the machine or
injury.
• Use caution when making turns.
• Slow down the machine before making
sharp turns.
Important:
If the motion-control lever does not
return to the N
EUTRAL
position when you release
it, contact an Authorized Service Dealer.
Important:
To begin moving the machine
(forward or backward), the parking-brake lever
must be released (pulled up) before you move the
motion-control lever.
Driving the Machine Forward
1. Move the motion-control lever to the N
EUTRAL
position.
2. Release the parking brake.
3. To drive the machine, perform the following:
•
To move the machine forward in a straight
line, center the steering control and move
the motion-control lever forward.
Note:
The machine moves faster the farther
you move the motion-control lever away from
the N
EUTRAL
position.
g020125
Figure 19
•
To turn left or right, move the steering control
toward the desired turn direction.
•
To stop the machine, move the motion-control
lever in the N
EUTRAL
position.
Note:
Stopping distance may vary
depending on the spreader-sprayer load.
Note:
When you release the motion-control
lever, it automatically returns to the N
EUTRAL
position.
22