Toro 34215, Руководство оператора

Страница: 65 / 80

Note:
The factory center-to-center
distance between the ball-joint rod ends
at the steering linkage is 23.3 cm (9.21
inches).
D. Tighten the jam nuts.
E. Align the holes in the front cover with the
clip nuts in the chassis and secure the cover
with the 4 thumb nuts that you removed in
A .
7. Remove the bolts that you installed in step 3
from the control column and steering control.
Servicing the Transaxle
Service Interval: Every 50 hours
Transaxle Oil Type: Toro® HYPR-OIL™ 500
hydraulic oil or Mobil® 1 15W-50
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page 50) .
2. Rotate counterclockwise the 2 quarter-turn
fasteners that secure the knee pad to the
chassis of the machine (
Figure 84 ).
g027155
Figure 84
1. Quick release screws 3. Oil expansion tank
2. Knee pad
3. Lift the knee pad up and rearward slightly and
remove the pad from the machine (
Figure 84 ).
4. Clean area around fluid-expansion tank and
remove cap (
Figure 84 ).
5. Check the fluid level in the expansion tank.
Note:
The fluid-level cover the bottom port in
tank
6. If the fluid level is too low, add the specified fluid
into the expansion tank.
7. Install the tank cap onto the expansion tank and
tighten the cap until it is snug (
Figure 84 ).
Note:
Do not overtighten the cap.
65