Toro 34215, Руководство оператора

Страница: 43 / 80

After Operation
After Operation Safety
General Safety
•
Park the machine on a level surface; shut off the
engine; engage the parking brake; remove the
key; and wait for all movement to stop before
leaving the operator’s position.
•
After you finish operating the machine for the day,
wash off all chemical residue from the outside of
the machine; refer to
Chemical Safety (page 16) .
•
Use full-width ramps for loading the machine into
a trailer or truck.
•
Tie the machine down securely to the trailer or
truck using straps, chains, cable, or ropes. Both
front and rear straps should be directed down and
outward from the machine.
•
Shut off the fuel before transporting or storing the
machine.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Replace any damaged spray wand components;
do not attempt to repair hoses, seals, nozzles, or
other wand components.
Cleaning and Lubricating
the Spreader
Service Interval: After each use
1. Drive the machine to a designated cleaning area
with a level surface.
2. Move the motion-control lever in the N
EUTRAL
position, shut off the engine, wait for all moving
parts to stop, remove key, and engage parking
brake.
3. Empty the hopper; refer to Emptying the
Spreader (page 26) .
4. Using a hose to spray the inside and outside of
the entire spreader with clean water.
Note:
Do not use a power washer to clean
the machine. The high-pressure water
can force residual-corrosive materials into
sprayer-spreader components.
5. Tilt the screen at the bottom of the hopper
forward to clean the bottom hopper components
(
Figure 48 ).
g033504
Figure 48
1. Hopper screen
6. Rotate the hopper screen down.
7. Disconnect the hopper rate-gate cable, place
the rate gate dial to a setting lower than
the maximum open position, and allow the
spreader-sprayer to empty completely; refer to
Emptying the Spreader (page 26) .
8. Connect the hopper rate-gate cable; refer to
Connecting the Rate-Gate Linkage (page 28) .
9. Apply water-displacing lubricant to the
components as shown in
Figure 49 .
g027297
Figure 49
43