Toro 34215, Руководство оператора

Страница: 26 / 80

Applied Material Weight Formula
Formula
(Original
material weight)
- (Remaining
material weight)
=
Applied material
weight
Example 11.3 kg (25 lb)
— 9 kg (20 lb)
3
=
2.3 kg (5 lb)
Note:
This calculation means that 2.3 kg (5 lb)
of material was applied to the 93 m 2 (1,000 ft 2 )
test course.
9. If necessary, adjust the drop-rate cam to achieve
the recommended application rate. Once you
achieve the correct application rate, repeat
this procedure an additional time to verify your
results.
Important:
Designate a new calibration
course each time, so that the turf is not
damaged by excessive application of
material.
Filling the Spreader Hopper
Maximum hopper weight capacity: 79 kg (175 lb)
1. Drive the machine to the work site.
2. Move the machine to a level surface, move
motion-control lever to the N
EUTRAL
position,
shut off the engine, wait for all moving parts to
stop, remove key, and engage parking brake.
3. Ensure that the wide-distribution impeller-gate
lever is in the fully forward (closed) position;
refer to
Wide-distribution Impeller-Gate Lever
(page 13) .
4. Use the Spreading Charts (page 29) to
determine the setting for the drop-rate cam
(
Figure 24 ).
Note:
If the setting is not listed for the type of
material that you are using, set the cam to the
setting with a lower value then adjust as needed.
g027326
Figure 24
1. Cover 3. Drop-rate cam
2. Hopper
5. Remove the cover from the hopper, add the
material that you are spreading, and install the
cover onto the hopper (
Figure 24 ).
Note:
Do not overload the hopper; the
maximum weight capacity of the hopper is 79
kg (175 lb).
Note:
You may place 1 extra bag of granular
product on top of the sprayer tank if necessary.
Emptying the Spreader
Removing the Impeller
1. Move the machine to a level surface, move
motion-control lever to the N
EUTRAL
position,
shut off the engine, wait for all moving parts to
stop, remove key, and engage parking brake.
2. Empty the hopper by scooping out as much of
the material as possible.
3. Remove the 4 thumbscrews that secure the front
cover ( below the impeller) to the chassis, and
remove the cover (
Figure 25 ).
26