TIGIEFFE Airo V Series, Руководство по эксплуатации и обслуживанию

Страница: 63 / 103

Use and Maintenance Manual - Series V8 E V10 E Page 63
The inclinometer does not require any adjustment since it is
calibrated in the factory before the machine is delivered.
This device controls the chassis inclination and when inclined over
the allowed value:
▪
it disables lifting
▪
it disables drive when platform exceeds a given height (varying
according to model).
▪
it warns of the instability condition by means of an audible
alarm and a warning light located on the platform (see “General
use instructions”).
The inclinometer checks the inclination with respect to the two axes
(X; Y). On machine models that have the same transversal and
longitudinal inclination limits, the control is carried out with reference
to one axis only (X-axis).
Check operation at least once a year.
To check the inclinometer operation according to the longitudinal
axis (generally X-axis ):
▪
using the platform control panel set the machine so as to place
a shim of dimension ( A+10 mm ) under the two rear or front
wheels (see following table).
▪
wait three seconds (operation delay set at factory) until the
danger red light turns on. With platform lowered (booms down,
telescopic boom in and jib at a height b10° and – 70°)
all manoeuvres are still possible. By lifting one of the booms
(excepting the Jib) and/or extending the telescopic boom with
respect to the horizontal, the control system of the machine
disables the lifting and drive controls, and the audible alarm is
activated;
▪ If the alarm does not go off CALL THE TECHNICAL
ASSISTANCE.
To check the inclinometer according to the transversal axis
(normally Y-Axis ):
▪
Using the platform control panel set the machine so as to place
a shim of dimension ( B+10 mm ) under the two side right or left
wheels (see following table).
Fig. 25
▪
wait three seconds (operation delay set at factory) until the danger red light turns on. With platform lowered (booms
down, telescopic boom in and jib at a height b10° and – 70°) all manoeuvres are still possible. By lifting one
of the booms (excepting the Jib) and/or extending the telescopic boom with respect to the horizontal, the control
system of the machine disables the lifting and drive controls, and the audible alarm is activated;
▪ If the alarm does not go off CALL THE TECHNICAL ASSISTANCE.
SHIMS V8 E V10 E
A [mm] 42 42
B [mm] 32 32
WARNING! The dimensions of shims A and B refer to max. allowed inclination as indicated in table
“TECHNICAL FEATURES”. To be used during the inclinometer calibration.