TIGIEFFE Airo V Series, Руководство по эксплуатации и обслуживанию

Страница: 41 / 103

Use and Maintenance Manual - Series V8 E V10 E Page 41
83 212 JIB POT ERROR Jib potentiometer signal error Open the platform control panel and check the joystick
wiring of the jib;
If wiring is correct, connect the console, enter the
ADJUSTMENTS menu and execute the procedure for the
acquisition of the JIB control joystick signal:
- bias position of Jib lifting (JIB UP MIN);
- maximum position of Jib lifting (JIB UP MAX);
- bias position of Jib lowering (JIB DOWN MIN);
- maximum position of Jib lowering (JIB DOWN MAX).
If the problem persists, try replacing the joystick.
If this is not solved, try replacing the CAN TILLER board in
the control panel.
83 230 MAST POT ERROR Mast potentiometer signal error Open the platform control panel and check the joystick
wiring of the mast;
If wiring is correct, connect the console, enter the
ADJUSTMENTS menu and execute the procedure for the
acquisition of the mast control joystick signal:
- bias position of mast lifting (MAST UP MIN);
- maximum position of Mast lifting (MAST UP MAX);
- bias position of Mast lowering (MAST DOWN MIN);
- maximum position of Mast lowering (MAST DOWN MAX).
If the problem persists, try replacing the joystick.
If this is not solved, try replacing the CAN TILLER board in
the control panel.
83 235 ROT POT ERROR Rotation potentiometer signal
error
Open the platform control panel and check the joystick
wiring of turret rotation;
If wiring is correct, connect the console, enter the
ADJUSTMENTS menu and execute the procedure for the
acquisition of the control joystick signal for turret rotation :
- bias position of right turret rotation (SWING RIGHT MIN);
- maximum position of right turret rotation (SWING RIGHT
MAX);
- bias position of the left turret rotation (SWING LEFT MIN)
- maximum position of left turret rotation (SWING LEFT
MAX).
If the problem persists, try replacing the joystick.
If this is not solved, try replacing the CAN TILLER board in
the control panel.
84 84 STEER SENSOR KO Steering Sensor error Check wiring of the steering sensor.
If wiring is correct, connect the console, enter the
ADJUSTMENTS menu and execute the procedure for the
signal acquisition again.
- with steering in centred position (SET STEER 0-POS);
- with steering fully to the right (SET STEER RIGHT);
- with steering fully to the left (SET STEER LEFT).
If the problem persists, try replacing the steering sensor.
85 226 VACC OUT RANGE Drive potentiometer signal out of
range
Execute the acquisition procedure PROGRAM VACC.
86 86 PEDAL WIRE KO Pedal connection error Check the pedal wiring.
86 229 POS. EB. SHORTED Electric brake positive output
always high
A) It is recommended that the wiring be checked in order to
verify if a positive is connected to the Smart driver output,
CNB # 1.
B) If, even after disconnecting the wire from the connector
pin, the controller output remains active with a high voltage
value, the problem is inside the controller and the Smart
Driver may be short-circuited. In this case replace the
controller.
87 227 HEIGHT SENSOR KO Lifting sensor signal (optional)
KO
Check the wiring of the optional control potentiometer of the
lift height.
If wiring is correct, then the potentiometer may be faulty: try
replacing it.
88 233 POWER MOS SHORT Internal power MOS short circuit Replace the controller.
89 245 PUMP VACC NOT OK Pump control not calibrated It is recommended repeating a "PROGRAM VACC”
procedure.