TIGIEFFE Airo V Series, Руководство по эксплуатации и обслуживанию

Страница: 51 / 103

Use and Maintenance Manual - Series V8 E V10 E Page 51
IT IS FORBIDDEN to lift up the machine by means of a lift truck, since there are no suitable
positioning points of the forks.
Once the machine has been placed on the vehicle platform fasten it by means of the same holes
used for lifting and/or the four slots provided on the chassis and indicated with the symbol of the
hook. To avoid breaking the platform overload controller, thus causing the machine to stop, DO
NOT fix the machine to the vehicle base by tying the platform (any model) or the last lifting boom.
Before carrying the machine check the stability grade. The platform must be fully lowered to
ensure adequate stability during the entire operation.
6.3. Emergency towing of the machine
In the event of a fault, carry out the following
operations to tow the machine:
1. Hook the machine to the provided holes.
2. Unscrew and remove the central cap of
the two reduction gears (on the two rear
driving wheels) by means of a 10 mm
Allen wrench key.
3. Remove the central dragging pin of the
reduction by means of a needle-nose
pliers, and reposition the central cap to
reduce the oil leaking.
4. Tow at a very slow speed (remember
that when the machine is being towed,
brakes are out of order).
Fig. 17
WARNING! THIS OPERATION MAY CAUSE OIL LEAKAGE FROM THE DRIVE REDUCTION GEARS.
To resume the normal operation, set back the machine to initial conditions and, if necessary, top up the oil level inside the
drive reduction gears.
Tow at a very slow speed (remember that when the machine is being towed, brakes are out of order).
Tow only on a flat ground.
Do not park the machine without brakes on.
With the brakes off, put wedges under the wheels to prevent the machine from moving accidentally.