TIGIEFFE Airo V Series, Руководство по эксплуатации и обслуживанию

Страница: 49 / 103

Use and Maintenance Manual - Series V8 E V10 E Page 49
6. HANDLING AND CARRYING
6.1. Handling
To handle the machine in normal operating conditions, follow the instructions given in chapter "USE INSTRUCTIONS"
under paragraph "Drive and steering”.
When the platform is completely lowered (booms down, telescopic boom completely in and jib at a height b10°
and – 70° with respect to horizontal axis) the machine can be handled (i.e. drive can be performed) at different speeds to
be freely selected by the user.
When the platform is lifted and exceeds a given height, the enabled machines (see chapter “Technical Features) can be
driven at a reduced spe ed (automatically) up to the height specified in chapter “Technical Features”.
WARNING!
Drive with lifted platform may be subject to different restrictions according to the country where the
machine is used. Find out about the legislative limits concerning this operation from the bodies of
Health and Safety at work.
It is absolutely forbidden to drive the machine when platform is lifted unless the ground is horizontal,
flat and steady.
Before carrying out any displacement operation, verify that no people are in proximity of the machine
and in any case proceed with the utmost caution.
Before handling the machine check that the connection plugs are disconnected from the power
supply source.
Check that there are no holes or steps on the floor and bear in mind machine overall dimensions.
If the machine while travelling hits a hump or a hole with platform lifted, the machine will rest on one
or both pot-hole guards with no danger to the operator.
Now, if you lower the platform completely, and both drive wheels are lifted from the ground, the
machine might not be able to quit the lock condition with its own means. Emergency towing is
necessary (see par. "Emergency towing").
Do not use the machine to tow other vehicles.
Before steering and driving the machine, check the actual position of the rotating turret through the
relevant stickers on the chassis to achieve the correct movement direction.
While the machine is being displaced with lifted platform, no horizontal loads can be loaded onto the
platform (operators on board are not allowed to pull wires or ropes, etc.).