TIGIEFFE Airo V Series, Руководство по эксплуатации и обслуживанию

Страница: 44 / 103

Use and Maintenance Manual - Series V8 E V10 E Page 44
5.2.4.
Battery charger warning light (D)
They allow to check the correct operation of the battery charger and the state of charging of the battery.
After plugging into the mains, the indicator starts flashing for a few seconds with red light, checking phase of the battery. Then the
phases of battery charge are started and displayed in sequence from fixed light first red, then yellow and finally green, which indicates
the end of charging.
No light or long flashing during battery charger feeding indicates malfunctioning.
5.2.5.
Platform control levers (E F G)
The various levers shown in the figure allow the platform to be operated. According to the various signs the corresponding movements
are activated. These controls can be operated only if the on-off key is set to ON down (ground control panel selected). Or if the
function FACTORY OVERRIDE is activated. We shall also remind you that the ground controls are to be used to operate the platform
only in emergency situations and must not be used for any other purposes.
5.2.6.
Emergency FACTORY OVERRIDE (H L)
It is an emergency function for a fast recovery of an operator blocked at height because trapped and/or unconscious, even in case
of blocking alarms like the OVERLOAD ALARM or in case of machine switched-off, through of the button or in case of turned off
machine through emergency stop buttons.
To activate the function, it is necessary:
1. Remove the fixing screw of door L, using a
10 mm hexagonal wrench. The 10 mm
wrench is not equipped.
2. Remove the door L removing the two lead
seal.
3. Set the ON/OFF locking, in the selector key
FACTORY OVERRIDE H and rotate it,
keeping it active, in clockwise rotation until
the activation of the audible alarm of the
machine which report the activation of the
function.
4. Operate with the platform control levers E -
F - G.
5. Once the emergency recovery is completed,
place the machine out of service and call the
technical assistance service to reset the
leaded seal.
Fig. 11
WARNING! The function FACTORY OVERRIDE is only for the quick recovery of an operator blocked at height
because trapped and/or unconscious. During the activation of the function FACTORY OVERRIDE, the functions
of the inclination control system and those of the platform load control and the ground and platform emergency
stops are not enabled. IT IS FORBIDDEN to use this function for different purposes.
A timer limits the use of the function to a maximum time of 10 minutes, beyond which it is automatically
disabled.
Do not use the machine if the protection door of the emergency of the system FACTORY OVERRIDE is absent,
or if it’s missing the leaded seal.
CALL THE TECHNICAL ASSISTANCE TO RESET THE SEAL