![Ti Lite AERO Z Скачать руководство пользователя страница 37](http://html.mh-extra.com/html/ti-lite/aero-z/aero-z_owners-manual_1114046037.webp)
3-3
Z Series Owners Manual
OM_Z_1212RevC
CHAPTER 3: FOOTRESTS
5. Place the end of a ruler on the floor and hold it vertically against the left corner of the footrest. See Figure 3-3.
Adjust the left side of the footrest to the desired height (not less than 2” of ground clearance) and tighten the Allen
screw in the left clamp so the left side of the footrest cannot change.
6. Repeat the procedure from Step 5 above on the right side of the footrest.
7. When both sides are set at an equal distance from the floor, make sure all four wheels are in contact with the floor
and make sure that the Allen screw in each clamp is in the rearward position. Fully tighten the two Allen screws
in the clamps that secure the footrest to the chair frame, making sure the clamp remains securely butted up
against the end of the frame tube.
Titanium Footrest with Flat ABS Cover
(Aero Z Series)
Adjusting the Height/Replacing
Tools Needed:
• 1/8” Allen Wrench
• Ruler
1. Loosen, but do not remove, the two Allen screws that engage the T-Nuts to the clamps that secure the footrest
to the frame. See Figure 3-4. Loosen the screws just enough to permit the footrest tubes to slide up and down
within the covers. Do not detach the footrest clamps from the frame.
2. If replacing the footrest, remove the old footrest and insert the new footrest tubes through the covers and into the
frame.
3. Place the end of a ruler on the floor and hold it vertically against the corner of the footrest. See Figure 3-3.
Adjust the footrest to the desired height (not less than 2” of ground clearance) and tighten the Allen screws in the
left and right clamp so the left footrest cannot change.
Note: When adjusting the height of the footrest, make sure that at least 1-3/4” of the extension tube remains up
inside the frame tube. See Figure 3-5.
4. Repeat the procedure from Step 2 above on the right side of the footrest.
5. When both sides are set at an equal distance from the floor, fully tighten the two Allen screws into the two T-Nuts
securing the footrest to the frame, making sure the covers remain securely butted up against the end of the frame
tube.
Figure 3-4
Aero Z Footrest Replacement
Footrest
Cover
Allen
Screws
Clamp
T-Nuts
Clamp
Plate
Frame
Figure 3-5
Footrest Height Adjustment
Footrest
Frame
Содержание AERO Z
