Thermo Scientific Dionex AutoTrace 280, Руководство оператора

Страница: 113 / 166

5 • Service
Doc. 065330-05 03/2020
105
Getting Started
Before removing the pump, follow the steps below to create and run a method that
will dry the line that runs from the pump to the switching valve. This prevents
leaking during the pump replacement.
1. In the AutoTrace software main window, click Methods . The Set Up Methods
window opens.
2. On the Set Up Methods window toolbar, click New .
3. In the Name box, enter Dry Lines as the method name.
4. Click the Edit button.
5. Under AutoTrace Method Step , expand the Solid-Phase Extract option to
display the SPE commands.
6. Double-click the Load Sample command and set the volume to 10.0 mL.
7. Double-click the Dry with Gas command and set the time to 0.5 min.
8. To save the method, click Save on the toolbar.
9. On the toolbar, click the down arrow next to Command and select Download
Method .
10. If the Set Up Methods window is not currently open, the Find Method
window opens. Double-click Dry Lines, the name of the method you want to
download.
11. When asked to confirm that you want to download the method to the Dionex
AutoTrace 280, click Yes .
12. Place the sample lines in an empty, clean container.
13. Run the Dry Lines method.
14. When the method has finished running, turn off the Dionex AutoTrace 280
power switch and disconnect the power cord from both its source and from
the Dionex AutoTrace 280 right-side panel.
HIGH VOLTAGE—Disconnect the main power cord from its source, as
well as from the right-side panel of the Dionex AutoTrace 280.