Thermo Scientific Antaris EX, Руководство пользователя

Страница: 15 / 108

Safety Considerations
The following Cautions and Warnings provide additional information
about fire safety and preventing burn hazards.
Warning The NIR source bulb may be very hot. It stays hot for up to 3 minutes
after you turn off your instrument. To avoid being burned or starting a
fire, handle the source assembly only by the exterior handle. The User’s
Guide shows the location of the NIR source inside the instrument.
Note
Touching the HeNe laser poses no burn hazard. If you must replace the
laser assembly, you can begin the procedure immediately after turning off
the instrument power.
Danger Never use a flammable gas to purge, pressurize or cool the instrument.
Heat from the source or internal electrical components could ignite a
flammable gas. All gases used to purge, pressurize or cool the instrument
must be free of moisture, oil and other reactive or infrared-absorbing
materials. Use only clean, dry air or clean, dry nitrogen in the enclosure.
Other gases, even inert gases such as argon (Ar), can damage the
instrument.
Lifting or moving
These instruments are heavy. For specific weights, see the model specific
specifications later in this manual. To avoid injury when lifting or moving
the instrument, heed the precautions that follow:
Danger For enclosures installed on a wheeled cart, use caution when moving the
cart.
Push only from the handle. Do not attempt to move the cart up or down
inclines greater than 10 degrees.
Thermo Fisher Scientific Antaris EX Safety, Installation, and Site Preparation Guide 9