Thermal Dynamics ULTRA-CUT 200 XT, Руководство по эксплуатации

Страница: 75 / 228

ULTRA-CUT 200 XT
Manual 0-5304 INSTALLATION 3-47
3.25 Complete the Installation
1. Remove the cap from the coolant tank. Fill the coolant tank to the level shown, with Thermal Dynamics coolant. The
coolant level is visible through the translucent coolant tank. The amount of coolant required varies with torch leads length.
Coolant Capabilities
Cat. Number and Mixture Mixture Protects To
7-3580 ‘Extra-CoolTM’ 25 / 75 10° F / -12° C
7-3581 ‘Ultra-CoolTM’ 50 / 50 27° F / -33° C
7-3582 ‘Extreme CoolTM’ Concentrate* -65° F / -51° C
* For mixing with D-I CoolTM 7-3583
Art # A-11536
Fill Range
Coolant Tank
2. After the complete system has been installed, check that the coolant has been pumped through the system as follows
(see NOTE):
NOTE!
Depending on the length of the torch leads, the system may require more
coolant after turning the system ON for the first time.
a. Place the ON/OFF Switch to ON.
b. After about 4 minutes the system may shut down if the leads are not full of coolant.
c. Place the ON/OFF switch to OFF. Add more coolant if needed
d. After 10 seconds place the ON/OFF switch to ON again.
e. Repeat steps ‘b’ through ‘d’ until the system no longer shuts down. Depending on the length of the torch leads this
sequence may need to be repeated.
f. After the system stays operational allow the pump to operate for ten minutes to properly purge any air from the cool-
ant lines before using the system.
3. Refill the reservoir and reinstall the filler cap.
4. Purge coolant from the torch before firing the torch. Ensure there are no leaks before use. If leaks are evident, consult
the coolant leak troubleshooting guide in the maintenance section of this manual.