Thermal Dynamics ULTRA-CUT 200 XT, Руководство по эксплуатации

Страница: 61 / 228

ULTRA-CUT 200 XT
Manual 0-5304 INSTALLATION 3-33
Included with the HE400XT are two 10’ hoses, supply (green) and return (red), that are to be connected to the matching colors
on left side of the HE400XT and to the supply and return fittings on the rear of the Ultra-Cut XT power supply. Hoses to the
RAS1000XT connect on the right side of the HE400XT.
!
CAUTION
Do NOT cross the coolant lines as this will not provide cooling for
the XT™ plasma torch as designed and void the warranty.
Attach and tighten all #6 JIC fittings with 11/16” (18mm) wrench. Do not overtighten as it will strip the fitting threads and will
cause a leak. Do not start the Ultra-Cut XT™ without coolant in the reservoir. An additional gallon (3.78l) of coolant is required
to compensate for the HE400XT being attached to the system. Monitor the fluid level while filling the Ultra-Cut XT. Do not allow
the coolant reservoir level to drop below minimum.
Attach the cable from J70 on the power supply to J71 on the HE400XT after the Cooler and coolant lines have been determined
to be leak free.
Art # A-09624_A
B
Under low power plasma cutting the HE400XT may not come on. This is normal operation.
Periodically check obstructions in the radiator and remove them by vacuuming the fins. Do not use cleaners or fluids to remove
debris, they may affect the radiator integrity.